Dlp- D85 Lock Node Security - Cisco ONS 15454 SDH Procedure Manual

Chapter 17 DLPs D1 to D99
DLP-D85 Lock Node Security
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution This task is irreversible. Do not proceed unless you want the node to permanently have two IP addresses.
Click the Provisioning > Security > Data Comm tabs.
Step 1
Click Lock.
Step 2
In the Confirm Lock Secure Mode dialog box, click Yes.
Step 3
Return to your originating procedure (NTP).
Step 4
DLP-D86 Modify MIC-C/T/P Port IP Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Provisioning an IP address that is incompatible with the ONS 15454 SDH network might be service
Caution
affecting.
Click the Provisioning > Security > Data Comm tabs.
Step 1
Modify the following fields, as necessary:
Step 2
•
78-17194-01
This task locks the ONS 15454 SDH security mode. When security mode
is locked, two IP addresses must always be provisioned for the node, one
for the TCC2P LAN (TCP/IP) port, and one for the MIC-C/T/P LAN port.
TCC2P cards must be installed.
DLP-D60 Log into CTC, page 17-49
DLP-D84 Enable Node Security Mode, page 17-77
As needed
Onsite or remote
Superuser
This task modifies the ONS 15454 SDH MIC-C/T/P IP address, subnet
mask, and default router. It also modifies settings that control MIC-C/T/P
IP address visibility in CTC and the ONS 15454 SDH LCD. To perform
this task, secure mode must be enabled.
TCC2P cards must be installed.
NTP-D108 Back Up the Database, page 15-5
DLP-D60 Log into CTC, page 17-49
DLP-D84 Enable Node Security Mode, page 17-77
As needed
Onsite or remote
Superuser
IP Address

DLP- D85 Lock Node Security

Cisco ONS 15454 SDH Procedure Guide, R7.0
17-79