Dlp- D314 Assign A Name To A Port - Cisco ONS 15454 SDH Procedure Manual

Chapter 20 DLPs D300 to D399
From the Slot drop-down list, choose the STM-N card to map the low-order VC3, VC11, or VC12 circuit
Step 7
for optical transport or to map the VC4 circuit to an STM.
Step 8 Click Next.
Choose the destination VC4, TUG3, TUG2, and VC12 from the drop-down lists that appear.
Step 9
Check Use Secondary Destination and repeat Steps
Step 10
Return to your originating procedure (NTP).
Step 11
DLP-D314 Assign a Name to a Port
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card that has the port you want to provision.
Step 1
Click the Provisioning tab.
Step 2
Step 3 Click the Port Name column for the port number you are assigning a name to and enter the desired port
name.
The port name can be up to 32 alphanumeric/special characters and is blank by default.
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
DLP-D315 Log Out a User on a Single Node
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Security > Active Logins tabs.
Step 1
Choose the user that you want to log out and click Logout.
Step 2
78-17194-01
1
This task assigns a name to a port on any ONS 15454 SDH card.
None
DLP-D60 Log into CTC, page 17-49
NTP-D24 Verify Card Installation, page 4-2
As needed
Onsite or remote
Provisioning or higher
This task logs out a user from a single node.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Superuser

DLP- D314 Assign a Name to a Port

through 9.
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-7