Dlp- D340 Change Line And Threshold Settings For The E3-12 Cards - Cisco ONS 15454 SDH Procedure Manual

Chapter 20 DLPs D300 to D399
Table 20-13
Parameter
VC LO
VC4
15 Min radio button
1 Day radio button
Note
Return to your originating procedure (NTP).
Step 7
DLP-D340 Change Line and Threshold Settings for the E3-12 Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note For the default values and domains of user-provisionable card settings, refer to the "Network Element
Defaults" appendix in the Cisco ONS 15454 SDH Reference Manual.
Step 1 In node view, double-click the E3-12 card where you want to change the line or threshold settings.
Step 2 Click the Provisioning tab.
Step 3 Depending on the setting you need to modify, click the Line, Line Thresholds, Elect Path Thresholds,
or SDH Thresholds subtab.
Note
Note
78-17194-01
SDH Threshold Options for E1-N-14 and E1-42 Cards (continued)
Description
Virtual circuit (low-order)
Virtual circuit 4
Clicking this radio button and then clicking Refresh will cause the
threshold values on this tab to display for 15-minute intervals.
Clicking this radio button and then clicking Refresh will cause the
threshold values on this tab to display for 1-day intervals.
The threshold value appears after the circuit is created.
This task changes the line and threshold settings for the E3-12 cards.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
See Chapter 9, "Manage Alarms"
If you want to modify a threshold setting, it might be necessary to click on the available
directional, type, and interval (15 Min, 1 Day) radio buttons and then click Refresh. This will
display the desired threshold setting.

DLP- D340 Change Line and Threshold Settings for the E3-12 Cards

for information about the Alarm Profiles tab.
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-43