Ntp- D13 Perform The Shelf Installation Acceptance Test - Cisco ONS 15454 SDH Procedure Manual

NTP- D13 Perform the Shelf Installation Acceptance Test

Figure 1-4
FMEC cover
Hinge-locking
Attach the ground wire to the shelf.
Step 4
Attach the washer and nut.
Step 5
Attach the cover to the shelf using the screws on the top of the cover.
Step 6
Stop. You have completed this procedure.
NTP-D13 Perform the Shelf Installation Acceptance Test
Purpose
Tools/Equipment
Prerequisite Procedures Applicable procedures in
Required/As Needed
Onsite/Remote
Security Level
Complete
Step 1
Cisco ONS 15454 SDH Procedure Guide, R7.0
1-18
ONS 15454 SDH FMEC Cover
Pin hinge
spring
Use this procedure to perform a shelf installation acceptance test.
Voltmeter
Oval and/or block ferrites
Required
Onsite
None
Table 1-2 by verifying that each applicable procedure was completed.
F A N
F A IL
C R
IT
M A
J
M IN
Chapter 1, "Install the Shelf and FMECs."
Chapter 1 Install the Shelf and FMECs
78-17194-01