Ntp- D233 Change The Node Timing Reference - Cisco ONS 15454 SDH Procedure Manual

NTP- D233 Change the Node Timing Reference

NTP-D233 Change the Node Timing Reference
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
timing reference. If you are already logged in, continue with
Complete the
Step 2
needed.
Complete the
Step 3
page 20-76
Stop. You have completed this procedure.
NTP-D265 View the ONS 15454 SDH Timing Report
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
of the node timing references. If you are already logged in, continue with
Click the Maintenance > Timing > Report tabs.
Step 2
In the Timing Report area, you can view node timing information. The date and time of the report appear
Step 3
at the top of the report. The time stamp is the same as the alarms time stamp and can be configured using
the
describes the report fields and entries.
Step 4 To update the report, click the Reset button.
Cisco ONS 15454 SDH Procedure Guide, R7.0
15-18
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D368 Manual or Force Switch the Node Timing Reference" task on page 20-75
"DLP-D369 Clear a Manual or Force Switched Node Timing Reference" task on
as needed.
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D112 Display Alarms and Conditions Using Time Zone" task on page
This procedure enables you to switch the node timing reference to
enable maintenance on a timing reference or to return the node timing to
normal operation.
None
NTP-D28 Set Up Timing, page 4-9
As needed
Onsite or remote
Maintenance or higher
This procedure displays a current status report of the ONS 15454 SDH
timing references.
None
NTP-D28 Set Up Timing, page 4-9
As needed
Onsite or remote
Retrieve or higher
Chapter 15
at the node where you want to change the
Step 2.
at the node where you want to view a report
Step 2.
18-15.
Maintain the Node
as
Table 15-2
78-17194-01