Dlp- D493 Provision The Ethernet Port Of The Ml-Series Card - Cisco ONS 15454 SDH Procedure Manual

Chapter 21 DLPs D400 to D499
DLP-D493 Provision the Ethernet Port of the ML-Series Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the ML-Series card where you want to provision the Ethernet port.
Step 1
Step 2 Click the Provisioning > Ether Ports tabs.
The Ether Ports pane appears.
In the Ether Ports pane complete the following:
Step 3
•
•
Note
•
•
•
•
•
•
•
•
•
Click Apply.
Step 4
Reprovisioning an Ethernet port on the ML-Series card does not reset the ethernet statistics for that port.
Step 5
The Ethernet Statistics must be refreshed. To do so, do the following:
78-17194-01
This task provisions the Ethernet ports of the ML-Series card to carry
traffic.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite
Provisioning or higher
Port—Displays a fixed number identifier for the specific port.
Port Name—Enter a 12 character alphanumeric identifier for the port.
Circuit table displays port name of the POS port and not the Ethernet port.
Admin State—Displays the state of the port. Allowed values are UP and DOWN. For the UP value
to appear, the Ethernet port must be both administratively active and have a SONET/SDH circuit
provisioned.
PSAS (Pre Service Alarm Suppress)—Check the PSAS checkbox to enable alarm suppression on
the port for a time interval set in the Soak Time column. Uncheck the PSAS checkbox to disbale
alarm suppression.
Soak Time—Enter a desired soak time in hours and minutes (hh:mm) format. Use this column when
you have checked PSAS to suppress alarms. Once the port detects a signal, the countdown begins
for the designated soak time. Soak time hours can be set from 0 to 48. Soak time minutes can be set
from 0 to 45 in 15 minute increments.
Link State—Displays the status between signaling points at port and attached device. Allowed
values are UP or DOWN.
MTU (Maximum Transmission Unit)— Displays the largest acceptable packet size configured for
the port.
Speed—Displays the Ethernet port transmission speed.
Duplex—Displays the duplex mode setting for the port.
Flow Control—Displays the flow control mode negotiated with peer device.
Optics— Displays the Small form-factor pluggable (SFP) physical media type.
Click the Performance > Ether Ports > Statistics tabs.
a.
Click Refresh.
b.

DLP- D493 Provision the Ethernet Port of the ML-Series Card

Cisco ONS 15454 SDH Procedure Guide, R7.0
21-49