Ntp- D203 Modify Or Delete Card Protection Settings - Cisco ONS 15454 SDH Procedure Manual

Chapter 11 Change Node Settings
NTP-D203 Modify or Delete Card Protection Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Modifying and deleting protection groups can be service affecting.
Caution
Compete the
Step 1
Step 2.
Complete the
Step 2
Perform any of the following tasks as needed:
Step 3
•
•
•
•
Complete the
Step 4
Stop. You have completed this procedure.
NTP-D277 Modify or Delete Communications Channel
Terminations and Provisionable Patchcords
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Step 2.
78-17194-01
This procedure modifies or deletes card protection settings.
None
NTP-D170 Create Protection Groups, page 4-10
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page
"NTP-D108 Back Up the Database" procedure on page
DLP-D150 Modify a 1:1 Protection Group, page 18-42
DLP-D152 Modify a 1:N Protection Group, page 18-44
DLP-D154 Modify a 1+1 Protection Group, page 18-46
DLP-D155 Delete a Protection Group, page 18-47
"NTP-D108 Back Up the Database" procedure on page
This procedure changes or deletes RS-DCC or MS-DCC terminations and
deletes provisionable patchcords on the ONS 15454 SDH.
None
DLP-D363 Provision Regenerator-Section DCC Terminations, page 20-68
DLP-D364 Provision Multiplex-Section DCC Terminations, page 20-71
DLP-D40 Create a Provisionable Patchcord, page 17-31
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page

NTP- D203 Modify or Delete Card Protection Settings

17-49. If you are already logged in, continue with
15-5.
15-5.
17-49. If you are already logged in, continue with
Cisco ONS 15454 SDH Procedure Guide, R7.0
11-5