Dlp- D263 Edit Sncp Dual-Ring Interconnect Circuit Hold-Off Timer - Cisco ONS 15454 SDH Procedure Manual

Chapter 19 DLPs D200 to D299
Click OK. Circuits matching the attributes in the Filter Circuits dialog box appear in the Circuits
Step 5
window.
Step 6 To turn filtering off, click the Filter icon in the lower right corner of the Circuits window. Click the icon
again to turn filtering on, and click the Filter button to change the filter attributes.
Step 7 Return to your originating procedure (NTP).
DLP-D263 Edit SNCP Dual-Ring Interconnect Circuit Hold-Off Timer
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Click the Circuits tab.
Step 2
Click the SNCP circuit you want to edit, then click Edit.
Step 3
In the Edit Circuit window, click the SNCP Selectors tab.
Step 4
In the Hold-off Timer column, double-click the cell of the circuit span you want to edit, then type the
Step 5
new hold-off time. The range is 0 to 10,000 ms in increments of 100.
Repeat
Step 6
Click Apply, then close the Edit Circuit window by choosing Close from the File menu.
Step 7
Step 8 Return to your originating procedure (NTP).
78-17194-01
This task changes the amount of time a path selector switch is delayed for
circuits routed on an SNCP dual-ring interconnect (DRI) topology. In
DRIs, switching contention might occur depending upon the relative
switching speed of the path selector and the transmission delay on the
alternative routes. The hold-off time (HOT) allows you to change switch
times to prevent the switching contention.
None
NTP-D44 Provision SNCP Nodes, page 5-22
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Step 5, as needed, to adjust the hold-off timer for each circuit span.

DLP- D263 Edit SNCP Dual-Ring Interconnect Circuit Hold-Off Timer

Cisco ONS 15454 SDH Procedure Guide, R7.0
19-67