Dlp- D353 Provision G-Series Flow Control Watermarks - Cisco ONS 15454 SDH Procedure Manual

DLP- D353 Provision G-Series Flow Control Watermarks

Figure 20-12
Card View
Performance
POS Ports
Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 3
View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Step 4
Port # columns. For PM parameter definitions, refer to the "Performance Monitoring" chapter in the
Cisco ONS 15454 SDH Reference Manual.
Note
Step 5 Return to your originating procedure (NTP).
DLP-D353 Provision G-Series Flow Control Watermarks
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the G-Series card graphic to open the card.
Step 1
Cisco ONS 15454 SDH Procedure Guide, R7.0
20-58
POS Ports on the Card View Performance Window
tab
tab
Refresh
button
To refresh, reset, or clear PM counts, see the
on page 8-2.
This task provisions the buffer memory levels for flow control on G-Series
Ethernet ports.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Chapter 20
Auto-refresh
"NTP-D257 Change the PM Display" procedure
DLPs D300 to D399
Baseline
button
78-17194-01