Dlp- D434 Run The Ctc Installation Wizard For Unix - Cisco ONS 15454 SDH Procedure Manual

Chapter 21 DLPs D400 to D499
h.
i.
In the Cisco Transport Controller Installation wizard, click Next. The online user manuals install.
Step 12
Click Finish.
Step 13
Return to your originating procedure (NTP).
Step 14
DLP-D434 Run the CTC Installation Wizard for UNIX
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
If you will log into nodes running CTC software earlier than R4.6, uninstall JRE 1.4.2 or 4.0 and reinstall
Note
JRE 1.3.1_2. To run Software R7.0, uninstall JRE 1.3.1_2 and reinstall JRE 1.4.2 or 5.0. Software R7.0
supports JRE 1.4.2 or JRE 5.0; JRE 1.4.2 is provided on the software CD.
JRE 1.4.2 requires Netscape 7.x or Internet Explorer 6.x
Note
Verify that your computer has the following:
Step 1
•
•
•
78-17194-01
Click Next.
Click Finish.
If you are uninstalling the JRE, click Remove.
Note
This task installs the CTC online user manuals, Acrobat Reader 6.0.1,
JRE 1.4.2, and the CTC JAR files. JRE 1.4.2 is required to run CTC
Software R7.0. Preinstalling the CTC JAR files saves time at initial login.
If the JAR files are not installed, they are downloaded from the
TCC2/TCC2P card the first time you login.
Cisco ONS 15454 SDH Release 7.0 software CD
Required if any of the following are true:
•
•
•
Onsite or remote
None
RAM—384 MB recommended, 512 MB optimum
Hard drive—20 GB hard drive recommended with at least 50 MB of space available
Operating System—Solaris 8 or 9
Note These requirements are guidelines. CTC performance is faster if your computer has a faster
processor and more RAM.
JRE 1.4.2 or JRE 5.0 is not installed.
CTC online user manuals are not installed and are needed.
CTC JAR files are not installed and are needed.
Cisco ONS 15454 SDH Procedure Guide, R7.0

DLP- D434 Run the CTC Installation Wizard for UNIX

21-21