Table - Cisco ONS 15454 SDH Procedure Manual

Chapter 21 DLPs D400 to D499
From the Variable drop-down list, choose the variable. See
Step 6
threshold variables available in this field in line rate mode. See
threshold variables available in this fields in enhanced mode.

Table 21-3

Variable
iflnOctets
ifInDiscards
iflnErrors
ifOutOctets
ifOutDiscards
txTotalPkts
rxTotalPkts
fibreStatsInvalidOrderedSets
fibreStatsEncodingDispErrors
fibreStatsRxFramesTooLong
fibreStatsRxFramesBadCRC
fibreStatsRxFrames
fibreStatsRxOctets
fibreStatsTxFramesBadCRC
fibreStatsTxFrames
fibreStatsTxOctets
fibreStatsLinkResets
gfpStatsRxSBitErrors
gfpStatsRxMBitErrors
gfpStatsRxTypeInvalid
gfpStatsRxSblkCRCErrors
78-17194-01
FC_MR-4 Threshold Variables for Fibre Channel/FICON Line Rate Mode
(MIBs)
Definition
Total number of octets received on the interface, including
framing octets.
The number of inbound packets that were chosen to be discarded
even though no errors had been detected to prevent their being
deliverable to a higher-layer protocol.
Number of inbound packets discarded because they contain
errors.
Total number of transmitted octets, including framing packets.
The number of outbound packets that were chosen to be discarded
even though no errors had been detected to prevent their being
transmitted.
Total number of transmit packets.
Total number of receive packets.
Received ordered sets that are not recognized as part of the
defined Fibre Channel control words.
Received control words that cannot be decoded due to invalid
disparity.
Received oversize Fibre Channel frames > 2148 including cyclic
redundancy check (CRC).
Received Fibre Channel frames with bad CRC.
Received total Fibre Channel frames.
Received total Fibre Channel data bytes within a frame.
Transmitted Fibre Channel frames with bad CRC.
Transmitted total Fibre Channel frames.
Transmitted total Fibre Channel data bytes within a frame.
Total number of link resets initiated by FCMR port when link
recovery port setting is enabled.
Received generic framing protocol (GFP) frames with single bit
errors in the core header (these errors are correctable).
Received GFP frames with multiple bit errors in the core header
(these errors are not correctable).
Received GFP frames with invalid type (these are discarded). For
example, receiving GFP frames that contain Ethernet data when
Fibre Channel data is expected.
Total number of superblock CRC errors with the receive
transparent GFP frame. A transparent GFP frame has multiple
superblocks that each contain Fibre Channel data.
DLP- D465 Create FC_MR-4 RMON Alarm Thresholds
Table 21-3 for a list of the FC_MR-4
Table 21-4 for a list of the FC_MR-4
Cisco ONS 15454 SDH Procedure Guide, R7.0
21-41