Dlp- D167 Add A Static Tid To Nsap Entry To The Tarp Data Cache - Cisco ONS 15454 SDH Procedure Manual

Chapter 18 DLPs D100 to D199
Click Apply.
Step 3
Return to your originating procedure (NTP).
Step 4
DLP-D167 Add a Static TID to NSAP Entry to the TARP Data Cache
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step 1
Click Add Static Entry.
Step 2
In the Add Static Entry dialog box, enter the following:
Step 3
•
•
Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the
Step 4
Add Static Entry dialog box.
Return to your originating procedure (NTP).
Step 5
DLP-D168 Remove a Static TID to NSAP Entry from the TARP Data Cache
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step 1
Click the static entry that you want to delete.
Step 2
Click Delete Static Entry.
Step 3
78-17194-01
This task adds a static TID to NSAP entry to the TDC. The static entries are
required for NEs that do not support TARP and are similar to static routes.
For a specific TID, you must force a specific NSAP.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioner or higher
TID—Enter the TID of the NE. (For ONS nodes, the TID is the Node Name parameter on the node
view Provisioning > General tab.)
NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
This task removes a static TID to NSAP entry from the TDC.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioner or higher

DLP- D167 Add a Static TID to NSAP Entry to the TARP Data Cache

Cisco ONS 15454 SDH Procedure Guide, R7.0
18-57