Ntp- D289 Create And Delete Ethernet Rmon Thresholds - Cisco ONS 15454 SDH Procedure Manual

Hide thumbs Also See for ONS 15454 SDH:
Table of Contents

Advertisement

Chapter 8
Monitor Performance
NTP-D289 Create and Delete Ethernet RMON Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Perform any of the following tasks as needed:
Step 2
Stop. You have completed this procedure.
NTP-D254 Monitor STM-N Performance
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
are already logged in, continue with Step 2.
Complete the
Step 2
page 18-19
Complete the
Step 3
needed to enable or disable monitoring of VC4 traffic through intermediate nodes.
Step 4
Complete the
78-17194-01
This procedure creates or deletes Ethernet remote monitoring (RMON)
thresholds for the ONS 15454 SDH.
None
As needed
Onsite or remote
Provisioning or higher
"DLP-D60 Log into CTC" task on page
DLP-D441 Create Ethernet RMON Alarm Thresholds, page 21-28
DLP-D436 Delete Ethernet RMON Alarm Thresholds, page 21-25
This procedure enables you to view node near-end or far-end
performance during selected time intervals on an STM-N card and port
to detect possible performance problems.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and Low-Order Tunnels"
As needed
Onsite or remote
Retrieve or higher
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D121 Enable Pointer Justification Count Performance Monitoring" task on
as needed to enable or disable clock synchronization monitoring.
"DLP-D122 Enable Intermediate Path Performance Monitoring" task on page 18-21
"DLP-D421 View STM-N PM Parameters" task on page

NTP- D289 Create and Delete Ethernet RMON Thresholds

17-49. If you are already logged in, continue with
Chapter 6, "Create Circuits
and
Chapter 10, "Change Card Settings."
at the node that you want to monitor. If you
21-2.
Cisco ONS 15454 SDH Procedure Guide, R7.0
as
8-5

Advertisement

Table of Contents
loading

Table of Contents