Table - Cisco ONS 15454 SDH Procedure Manual

DLP- D211 Provision CE-1000-4 Ethernet Ports
DLP-D211 Provision CE-1000-4 Ethernet Ports
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You can provision SDH contiguous concatenated (CCAT) or virtual concatenated (VCAT) circuits for
Note
the CE-1000-4 before or after provisioning the card's Ethernet ports and/or packet-over-SDH (POS)
ports. See the
or the
CCAT circuits can be created only if a contiguous pool of VCs is available. The Ethernet ports are
Note
automatically allocated VCs from the available Cisco ONS 15454 SDH bandwidth on the CE-1000-4
card.
In node view, double-click the CE-1000-4 card graphic to open the card.
Step 1
Click the Provisioning > Ether Ports tabs.
Step 2
For each CE-1000-4 port, provision the following parameters:
Step 3
•
Note
•
•
•
•
•
Click Apply.
Step 4
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-8
This task provisions CE-1000-4 Ethernet ports to carry traffic.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
"NTP-D323 Create an Automatically Routed High-Order Circuit" procedure on page 6-55
"NTP-D283 Create an Automatically Routed VCAT Circuit" procedure on page
Port Name—If you want to label the port, enter the port name.
Circuit table displays port name of the POS port and not the Ethernet port.
Admin State—Select the service state for the port. See the
a Port" task on page 19-10
Flow Control—Select the flow control for the port. Possible values are None, Symmetrical, and
Pass Through.
Auto Negotiation—Click this check box to enable autonegotiation on the port (default). If you do
not want to enable autonegotiation control, uncheck the box.
MTU—If you want to permit the acceptance of jumbo size Ethernet frames, choose 10004 (default).
If you do not want to permit jumbo size Ethernet frames, choose 1548.
Watermark—Select the flow control watermark for the port. To provision the Low Latency flow
control watermark, choose Low Latency from the drop-down list. The Flow Ctrl Lo and Flow Ctrl
Hi values change. To provision a Custom flow control watermark, choose Custom from the
drop-down list.
Enter values in the Flow Ctrl Hi and Flow Ctrl Lo columns. The Flow Ctrl Lo value has a valid range
from 1 to 510 and the Flow Ctrl Hi value has a valid range from 2 to 511. The Flow Ctrl Lo value
must be lower than the Flow Ctrl Hi value.
for more information.
Chapter 19 DLPs D200 to D299
6-97, as needed.
"DLP-D214 Change the Service State for
78-17194-01