Dlp- D428 Modify Alarm, Condition, And History Filtering Parameters - Cisco ONS 15454 SDH Procedure Manual

DLP- D428 Modify Alarm, Condition, and History Filtering Parameters

Note
Click the node names in the Node Names list to highlight the profile location.
Step 4
Tip
Click the profile name(s) you want to delete in the Profile Names list.
Step 5
Click OK.
Step 6
Click Yes in the Delete Alarm Profile dialog box.
Step 7
Note
To remove the alarm profile from the window, right-click the column of the profile you deleted and
Step 8
choose Remove from the shortcut menu.
Note
Note
Step 9 Return to your originating procedure (NTP).
DLP-D428 Modify Alarm, Condition, and History Filtering Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
At node, network, or card view, click the Alarms, Conditions, or History tab.
Step 1
Cisco ONS 15454 SDH Procedure Guide, R7.0
21-12
A previously created alarm profile cannot be deleted unless it has been stored on the node. If the
profile is visible on the Alarm Profiles tab but is not listed in the Select Node/Profile
Combinations to Delete dialog box, continue with
If you hold the Shift key down, you can select consecutive node names. If you hold the Ctrl key
down, you can select any combination of nodes.
If you delete a profile from a node, it still appears in the network view Provisioning >
Alarm Profiles window unless you remove it using the following step.
If a node and profile combination is selected but does not exist, a warning appears: "One or more
of the profile(s) selected do not exist on one or more of the node(s) selected." For example, this
warning appears if Node A has only Profile 1 stored and the user tries to delete both Profile 1
and Profile 2 from Node A. However, the operation still removes Profile 1 from Node A.
The Default and Inherited special profiles cannot be deleted and do not appear in the
Select Node/Profile Combination for Delete window.
This task changes alarm and condition reporting in all network nodes.
None
DLP-D225 Enable Alarm Filtering, page 19-24
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
Chapter 21
Step 8.
DLPs D400 to D499
78-17194-01