Ntp-H158 Install The Electrical Cables; Ntp-H160 Install Optical Cables; Step 1 - Cisco ONS 15310-MA SDH Procedure Manual

Required Tools and Equipment
NTP-H191 Install the Rear Cover
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Always use the supplied ESD wristband when working with a powered ONS 15310-MA SDH. For
detailed instructions on how to wear the ESD wristband, refer to the
(ESD) and Grounding
Connect all cables on the backplane before installing the rear cover.
Note

Step 1

Using a #2 Phillips screw driver, remove the six panhead screws from the Electrical Interface Assemblies
(EIAs) located on the A-side and B-side of the backplane
Cisco ONS 15310-MA SDH Procedure Guide, R9.0
1-36
This procedure explains how to install the rear cover on an ONS 15310-MA
SDH shelf.
#2 Phillips screwdriver
•
1/4-inch nut driver
•
Six 1/4-inch hexagonal standoffs 6-32 x 3.3.25
•
NTP-H158 Install the Electrical Cables, page 1-26
NTP-H160 Install Optical Cables, page 1-28
Required
Onsite
None
Guide.
Chapter 1 Install the Cisco ONS 15310-MA SDH
Cisco ONS Electrostatic Discharge
(Figure 1-10).
78-18668-01