DLP- D428 Modify Alarm, Condition, and History Filtering Parameters
Figure 21-7
When filtering is enabled, conditions in the Show list are visible and conditions in the Hide list are
invisible.
•
To move conditions individually from the Show list to the Hide list, click the > button.
•
To move conditions individually from the Hide list to the Show list, click the < button.
To move conditions collectively from the Show list to the Hide list, click the >> button.
•
To move conditions collectively from the Hide list to the Show list, click the << button.
•
Note
Click Apply and OK.
Step 6
Alarm and condition filtering parameters are enforced when alarm filtering is enabled (see the
"DLP-D225 Enable Alarm Filtering" task on page
disabled (see the
Return to your originating procedure (NTP).
Step 7
Cisco ONS 15454 SDH Procedure Guide, R7.0
21-14
Alarm Filter Dialog Box Conditions Tab
Conditions include alarms.
"DLP-D227 Disable Alarm Filtering" task on page
Chapter 21
19-24), and are not enforced when alarm filtering is
19-25).
DLPs D400 to D499
78-17194-01