Dlp- D169 Add A Tarp Manual Adjacency Table Entry - Cisco ONS 15454 SDH Procedure Manual

DLP- D169 Add a TARP Manual Adjacency Table Entry

In the Delete TDC Entry dialog box, click Yes.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-D169 Add a TARP Manual Adjacency Table Entry
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > OSI > TARP > MAT tabs.
Step 1
Click Add.
Step 2
In the Add TARP Manual Adjacency Table Entry dialog box, enter the following:
Step 3
•
•
Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the Add Static
Step 4
Entry dialog box.
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15454 SDH Procedure Guide, R7.0
18-58
This task adds an entry to the TARP manual adjacency table (MAT). Entries
are added to the MAT when the ONS 15454 SDH must communicate across
routers or non-SDH NEs that lack TARP capability.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Level—Sets the TARP Type Code that will be sent:
Level 1—Indicates that the adjacency is within the same area as the current node. The entry
–
generates Type 1 PDUs.
Level 2—Indicates that the adjacency is in a different area than the current node. The entry
–
generates Type 2 PDUs.
NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
Chapter 18 DLPs D100 to D199
78-17194-01