Dlp- D264 Provision A J1 Path Trace On Circuit Source And Destination Ports - Cisco ONS 15454 SDH Procedure Manual

DLP- D264 Provision a J1 Path Trace on Circuit Source and Destination Ports

DLP-D264 Provision a J1 Path Trace on Circuit Source and Destination Ports
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This task assumes that you are setting up path trace on a bidirectional circuit and setting up transmit
Note
strings at the circuit source and destination.
From the View menu, choose Go to Network View.
Step 1
Click the Circuits tab.
Step 2
For the VC3 or VC4 circuit you want to monitor, verify that the source and destination ports are on a
Step 3
card that can transmit and receive the path trace string. See
Table 19-5
J1 Function
Transmit and receive
Receive only
Note
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-68
This task creates a J1 path trace on VC3 or VC4 circuit source ports and
destination ports or a VCAT circuit member.
ONS 15454 SDH cards capable of transmitting and/or receiving J1 path
trace must be installed at the circuit source and destination ports. See
Table 19-5 on page 19-68
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
ONS 15454 SDH Cards Capable of J1 Path Trace
Cards
E1-42
STM1E-12
E3-12
DS3i-N-12
OC3 IR 4/STM1 SH 1310
OC3 IR 4/STM1 SH 1310-8
OC12/STM4-4
OC48 IR/STM16 SH AS 1310
OC48 LR/STM16 LH AS 1550
OC192 SR/STM64 IO 1310
OC192 LR/STM64 LH 1550
OC192 IR/STM SH 1550
ML100T-12
ML1000-2
FC_MR-4
For FC_MR-4 cards, the path trace string must be identical for all members of the VCAT circuit.
Chapter 19
for a list of cards.
Table 19-5 for a list of cards.
DLPs D200 to D299
78-17194-01