Cisco ONS 15454 SDH Procedure Manual page 247

Chapter 6 Create Circuits and Low-Order Tunnels
Create cross-connects only (TL1-like)—Check this check box if you want to create one or more
•
cross-connects to complete a signal path for TL1-generated circuits. If you check this box, low-order
tunnels and Ethergroup sources and destinations are unavailable.
State—Choose IS. Ethergroup circuits are always in service.
•
• Apply to drop ports—Uncheck this box.
• Protected Drops—Leave the default unchanged (unchecked).
Step 11 If the circuit will be routed on an SNCP ring, complete the
During Circuit Creation" task on page
Layer 1 SDH protection does not extend to multicard EtherSwitch circuits on SNCP rings.
Caution
A TCC2/TCC2P card reset disrupts single-card and multicard Etherswitch circuits for 45 seconds to two
Caution
minutes. During this time, a spanning tree topology is created by the newly activated TCC2/TCC2P card.
Step 12 Click Next.
Provision the circuit source:
Step 13
From the Node drop-down list, choose one of the EtherSwitch circuit endpoint nodes. (Either end
a.
node can be the EtherSwitch circuit source.)
b. From the Slot drop-down list, choose one of the following:
•
•
Click Next.
Step 14
Provision the circuit destination:
Step 15
From the Node drop-down list, choose the second EtherSwitch circuit endpoint node.
a.
From the Slot drop-down list, choose one of the following:
b.
•
•
Click Next.
Step 16
In the Circuit VLAN Selection area, click New VLAN. If the VLAN already exists, continue with
Step 17
Step 20.
Tip
Step 18 In the New VLAN dialog box, complete the following:
• VLAN Name—Assign an easily identifiable name to your VLAN.
• VLAN ID—Assign a VLAN ID. The VLAN ID should be the next available number between 2 and
4093 that is not already assigned to an existing VLAN. Each ONS 15454 SDH network supports a
maximum of 509 user-provisionable VLANs.
78-17194-01
If you are building a multicard EtherSwitch circuit, choose Ethergroup.
If you are building a single-card EtherSwitch circuit, choose the Ethernet card where you
enabled the single-card EtherSwitch.
If you are building a multicard EtherSwitch circuit, choose Ethergroup.
If you are building a single-card EtherSwitch circuit, choose the Ethernet card where you
enabled the single-card EtherSwitch.
You can also add VLANs in network view by choosing Tools > Manage VLANs. In the
All VLANs dialog box, click the Create button to open the Define New VLAN dialog box.
NTP- D191 Create an E-Series EtherSwitch Circuit (Multicard or Single-Card Mode)
"DLP-D218 Provision SNCP Ring Selectors
19-17.
Cisco ONS 15454 SDH Procedure Guide, R7.0
6-73