Ntp- D283 Create An Automatically Routed Vcat Circuit - Cisco ONS 15454 SDH Procedure Manual

Chapter 6 Create Circuits and Low-Order Tunnels
Complete the
Step 1
where you will create the overhead circuit. If you are already logged in, continue with Step 2.
From the View menu, choose Go to Network View.
Step 2
As needed, complete the
Step 3
As needed, complete the
Step 4
As needed, complete the
Step 5
As needed, complete the
Step 6
Stop. You have completed this procedure.
NTP-D283 Create an Automatically Routed VCAT Circuit
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
circuit. If you are already logged in, continue with Step 2.
Complete the following as necessary (you can provision Ethernet or POS ports before or after the VCAT
Step 2
circuit is created):
•
•
•
•
•
Step 3 From the View menu, choose Go to Network View.
Click the Circuits tab, then click Create.
Step 4
In the Circuit Creation dialog box, choose VC_HO_PATH_VCAT_CIRCUIT from the Circuit Type
Step 5
drop-down list.
Step 6 Click Next.
78-17194-01
"DLP-D60 Log into CTC" task on page 17-49
"DLP-D361 Create a DCC Tunnel" task on page
"DLP-D4 Create an IP-Encapsulated Tunnel" task on page
"DLP-D83 Provision Orderwire" task on page
"DLP-D212 Create a User Data Channel Circuit" task on page
This procedure creates an automatically routed VCAT circuit. For more
information about VCAT circuits, refer to the "Circuits and Tunnels"
chapter in the Cisco ONS 15454 SDH Reference Manual.
ML-Series, CE-100T-8, CE-1000-4, or FC_MR-4 cards must be installed
at the nodes used in the VCAT circuit.
NTP-D127 Verify Network Turn-Up, page 6-5
As needed
Onsite
Provisioning or higher
"DLP-D60 Log into CTC" task on page 17-49
To provision Ethernet ports for CE-100T-8 circuits, complete the
Ethernet Ports" task on page
To provision Ethernet ports for CE-1000-4 circuits, complete the
Ethernet Ports" task on page
To provision POS ports for CE-100T-8 or CE-1000-4 circuits, complete the
CE-100T-8 and CE-1000-4 POS Ports" task on page
To provision Ethernet ports for ML-Series circuits, complete the
Port of the ML-Series Card" task on page
To provision POS ports for ML-Series circuits, complete the
the ML-Series Card" task on page

NTP- D283 Create an Automatically Routed VCAT Circuit

18-30.
19-8.
18-33.
21-49.
21-50.
Cisco ONS 15454 SDH Procedure Guide, R7.0
at an ONS 15454 SDH on the network
20-66.
17-3.
17-76.
at the node where you will create the VCAT
"DLP-D136 Provision CE-100T-8
"DLP-D211 Provision CE-1000-4
"DLP-D141 Provision
"DLP-D493 Provision the Ethernet
"DLP-D494 Provision the POS Port of
19-9.
6-97