Ntp- D169 Set Up Ctc Network Access - Cisco ONS 15454 SDH Procedure Manual

Chapter 4 Turn Up a Node
Click Apply.
Step 7
Stop. You have completed this procedure.
NTP-D169 Set Up CTC Network Access
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Step 2 Complete the
IP address, subnet mask, default router, DHCP, IIOP listener port, and SOCKS proxy server settings.
Tip
If you want to turn on the ONS 15454 secure mode, which allows two IP addresses to be provisioned for
Step 3
the node if TCC2/TCC2P cards are installed, complete the
on page
If static routes are needed, complete the
Step 4
the "CTC Network Connectivity" chapter in the Cisco ONS 15454 SDH Reference Manual for further
information about static routes.
If the ONS 15454 SDH is connected to a LAN or WAN that uses OSPF and you want to share routing
Step 5
information between the LAN or WAN and the ONS network, complete the
Change Open Shortest Path First Protocol" task on page
If the ONS 15454 SDH is connected to a LAN or WAN that uses RIP, complete the
Step 6
or Change Routing Information Protocol" task on page
Stop. You have completed this procedure.
78-17194-01
This procedure provisions network access for a node, including its subnet
mask, default router, Dynamic Host Configuration Protocol (DHCP)
server, IIOP (Internet Inter-Orb Protocol) listener port, SOCKS proxy
server settings, static routes, Open Shortest Path First (OSPF) protocol,
and Routing Information Protocol (RIP).
None
NTP-D24 Verify Card Installation, page 4-2
Required
Onsite or remote
Superuser
"DLP-D60 Log into CTC" task on page
"DLP-D249 Provision IP Settings" task on page 19-52
If you cannot log into the node, you might be able to change its IP address, default router, and
network mask by using the LCD on the ONS 15454 SDH front panel. See the
IP Address, Default Router, and Network Mask Using the LCD" task on page 17-53
instructions. However, you cannot use the LCD to provision any other network settings.
17-77.
17-49. If you are already logged in, continue with
"DLP-D84 Enable Node Security Mode" task
"DLP-D65 Create a Static Route" task on page
19-56.
19-58.
Cisco ONS 15454 SDH Procedure Guide, R7.0

NTP- D169 Set Up CTC Network Access

to provision the ONS 15454 SDH
"DLP-D64 Set the
for
17-56. Refer to
"DLP-D250 Set Up or
"DLP-D251 Set Up
4-7