Dlp- D442 Preprovision A Slot - Cisco ONS 15454 SDH Procedure Manual

Chapter 21 DLPs D400 to D499
Return to your originating procedure (NTP).
Step 14
DLP-D442 Preprovision a Slot
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, right-click the empty slot where you will later install a card.
Step 1
From the Add Card shortcut menu, choose the card type that will be installed. Only cards that can be
Step 2
installed in the slot appear in the Add Card shortcut menu.
Note
Step 3 Return to your originating procedure (NTP).
DLP-D457 Refresh E-Series and G-Series Ethernet PM Counts
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card where you want to view PM counts. The card view appears.
Step 1
Click the Performance > History tabs.
Step 2
From the Interval drop-down list, choose one of the following:
Step 3
•
•
78-17194-01
This task preprovisions a card slot in CTC before you physically install the
card in the ONS 15454 SDH.
None
Chapter 3, "Connect the PC and Log into the GUI"
As needed
Onsite or remote
Provisioning or higher
When you preprovision a slot, the card appears purple in the CTC shelf graphic, rather than
white when a card is installed in the slot. NP (not present) on the card graphic indicates that the
card is not physically installed.
1 min
15 min
This task changes the window view to display specified E-Series and
G-Series Ethernet PM counts in time intervals depending on the interval
option selected.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Retrieve or higher
Cisco ONS 15454 SDH Procedure Guide, R7.0

DLP- D442 Preprovision a Slot

21-33