Dlp- D103 Soft-Reset A Ce100T-8 Card Using Ctc - Cisco ONS 15454 SDH Procedure Manual

Chapter 18 DLPs D100 to D199
DLP-D103 Soft-Reset a CE100T-8 Card Using CTC
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Soft-resetting the CE100T-8 card is errorless in most cases. If there is a provisioning change during the
Note
soft reset, or if the firmware is replaced during the software upgrade process, the reset is not errorless.
In node view, right-click the CE100T-8 card to reveal a shortcut menu.
Step 1
Click Soft-reset Card.
Step 2
Step 3 Click Yes in the "Are you sure you want to soft-reset this card?" dialog box.
Step 4 Return to your originating procedure (NTP).
DLP-D104 Install the Fiber Clip on 15454_MRC-12 Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You can install the fiber clip before or after the fibers are attached to the 15454_MRC-12 card.
Note
Determine the correct clip to use. Use the short clip with a standard cabinet door and a long clip with an
Step 1
extended door.
Insert the prong of the fiber clip into the rectangular cutout on the sloped face of the faceplate
Step 2
(Figure
78-17194-01
This procedure soft-resets the CE100T-8 card.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Superuser
This task installs a fiber clip, which allows proper routing of the fiber.
Required for 15454_MRC-12 cards. In CTC, the 15454_MRC-12 card
appears as "MRC-12" only.
Short or long fiber clip, as needed
NTP-D16 Install STM-N Cards and Connectors, page 2-7
As needed
Onsite
None
18-1).

DLP- D103 Soft-Reset a CE100T-8 Card Using CTC

Cisco ONS 15454 SDH Procedure Guide, R7.0
18-3