Cisco ONS 15454 SDH Procedure Manual page 356

NTP- D210 Convert an SNCP to a Two-Fiber MS-SPRing Manually
If the MS-SPRing window appears with the MS-SPRing you created, go to
MS-SPRing" or "Error While Creating MS-SPRing" message appears, complete the following:
a.
b.
c.
d.
Note
Verify the following:
Step 9
•
•
Stop. You have completed this procedure.
NTP-D210 Convert an SNCP to a Two-Fiber MS-SPRing
Manually
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution This procedure is service affecting. All circuits on the ring are deleted and reprovisioned.
Read through this procedure completely before beginning the conversion.
Caution
Prior to beginning this procedure, you should have a unique ring ID name to identify the new MS-SPRing
Note
and a unique node ID number for each node on the ring.
Cisco ONS 15454 SDH Procedure Guide, R7.0
13-14
Click OK.
In the Create MS-SPRing window, click Excluded Nodes. Review the information explaining why
the MS-SPRing could not be created, then click OK.
Depending on the problem, click Back to start over or click Cancel to cancel the operation.
Complete the "NTP-D40 Provision MS-SPRing Nodes" procedure on page
steps are completed accurately, then start this procedure again.
Some or all of the following alarms might briefly appear during MS-SPRing setup:
E-W MISMATCH, RING MISMATCH, APSCIMP, APSDFLTK, and MS-SPRingOSYNC.
On the network view graphic, a green span line appears between all MS-SPRing nodes.
All E-W MISMATCH, RING MISMATCH, APSCIMP, DFLTK, and MS-SPRingOSYNC alarms are
cleared. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide for alarm troubleshooting.
This procedure converts an SNCP to an MS-SPRing manually, that is,
without using the in-service topology upgrade wizard. Use this
procedure if the wizard is unavailable or you need to back out of the
wizard.
None
NTP-D44 Provision SNCP Nodes, page 5-22
As needed
Onsite or remote
Provisioning or higher
Chapter 13 Convert Network Configurations
Step 9. If a "Cannot Create
5-10, making sure all
78-17194-01