Cisco ONS 15454 SDH Procedure Manual page 613

Chapter 19 DLPs D200 to D299
Table 19-2
Parameter
Recovery Pulse
Interval
Currently
Shutdown
Request Laser
Restart
Click Apply. If the change affects traffic, a warning message displays. Click Yes to complete the change.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-D217 MS-SPRing Exercise Ring Test
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Click the Provisioning > MS-SPRing tabs.
Step 2
Click the row of the MS-SPRing you will exercise, then click Edit.
Step 3
Step 4 Exercise the west port:
a.
78-17194-01
STM-N Maintenance Settings (continued)
Description
Sets the recovery laser pulse
interval, in seconds. This is the
period of time that must past before
the recover pulse is repeated.
(Display only) Displays the current
status of the laser.
If checked, allows you to restart the
laser for maintenance.
Restarting a laser might be
Note
traffic-affecting.
This task tests the multiplex section-shared protection ring (MS-SPRing)
functionality without switching traffic. Ring exercise conditions (including
the K-byte pass-through) are reported and cleared within 10 to 15 seconds.
None
DLP-D60 Log into CTC, page 17-49
As needed
Onsite or remote
Provisioning or higher
Right-click the west port of any MS-SPRing node and choose Set West Protection Operation.
Figure 19-4 shows an example. (To move a graphic icon, press Ctrl while you drag and drop it to a
new location.)
DLP- D217 MS-SPRing Exercise Ring Test
Options
Numeric. For the default values and
domains of user-provisionable card
settings, refer to the "Network Element
Defaults" appendix in the Cisco ONS 15454
SDH Reference Manual.
Numeric. For the default values and
domains of user-provisionable card
settings, refer to the "Network Element
Defaults" appendix in the Cisco ONS 15454
SDH Reference Manual.
Checked or unchecked
Cisco ONS 15454 SDH Procedure Guide, R7.0
19-15