Table of Contents
Advertisement
Figure 3-29 Installing a Dummy Filter module in an ONS 15252 MCU
DFM
Procedure: Interconnect the ONS 15252 MCU Passive Optical Shelf Modules
After positioning the HFMs, and installing the BMs or TMs, CMX or CMY, and DFMs, connect the
passive optical shelf modules to complete the passive optical shelf installation.
Step 1
When all HFMs, the BM/TM, the CMX/CMY, and the DFMs are installed in the passive optical shelf,
remove the dust plugs from the duplex MU adapter on the HFM closest to the LM (from left to right on
the A side and from right to left on the B side).
Remove the dust caps from the MU duplex connector connected to the LM.
Step 2
Clean and inspect the LM MU duplex fiber cable connector.
Step 3
Connect the LM MU duplex fiber jumper connector to the duplex MU adapter of the HFM closest to the
Step 4
LM.
Remove the dust plugs from the optical-fiber jumper cable connector in the HFM.
Step 5
Cisco ONS 15200 Installation, Setup, and Test Manual
3-40
Chapter 3
Installation
78-13765-01
Advertisement
Table of Contents
