Instal A Dual In-Line Memory Module (Dimm) - Cisco Catalyst 8300 Series Hardware Installation Manual

Instal a Dual In-line Memory Module (DIMM)

5. Lift the chassis cover after you have removed all the screws.
Note
•
•
•
•
•
•
•
•
Instal a Dual In-line Memory Module (DIMM)
Before you begin
There are four DDR4 DIMM slots. DIMMs have a polarization notch on the connecting edge to prevent
incorrect orientation of the module during insertion.
Figure 22: DIMM Showing Polarization Notch
1
These are the steps to install a DIMM:
1. Remove the chassis cover.
2. Locate the DIMM slots on the device. There are four DIMM slots in the chassis and you can install the
DIMM module on any of the slots.
3. Make sure that both latches on the DIMM connector are in the open position.
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
32
To replace the chassis cover, place the cover evenly on the top of the device and use the screws to secure it
to the device.
Instal a Dual In-line Memory Module (DIMM), on page 32
Removing a DIMM, on page 33
Installing the M.2 Storage Module, on page 34
Installing and Removing a Network Interface Module (NIM), on page 35
Installing Pluggable Interface Module, on page 36
Installing Drive Bays, on page 37
Replace (Remove and Install) Fan Tray, on page 40
Remove Small Form Pluggable Modules, on page 41
Install and Upgrade Field Replaceable Units
Polarization Notch