Ntp-B35 Verify Node Turn Up; Chapter 4 Turn Up Network - Cisco ONS 15327 Procedure Manual

NTP-B35 Verify Node Turn Up

12.
13.
14.
15.
16.
NTP-B35 Verify Node Turn Up
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
you are already logged in, proceed to Step 2.
Click the Alarms tab.
Step 2
a.
b.
Verify that the SW Version and Defaults displayed in the node view status area match the software
Step 3
version and network element (NE) defaults shown in your site plan. If any values are not correct,
complete the following procedures as needed:
•
•
Step 4 Click the Provisioning > General tabs. Verify that all general node information settings match the
settings of your site plan. If not, see the
on page
Click the Provisioning > Timing tabs. Verify that the timing settings match the settings on your site
Step 5
plan. If not, see the
Click the Provisioning > Network tabs. Ensure that the IP settings and other CTC network access
Step 6
information is correct. If not, see the
Cisco ONS 15327 Procedure Guide, R4.0
4-2
NTP-B226 Provision a Path Protection Dual Ring Interconnect, page
this procedure after you provision path protection.
NTP-B227 Provision an Integrated Path Protection Dual Ring Interconnect, page
complete this procedure after you provision path protection.
NTP-B46 Subtend a Path Protection from a BLSR, page
NTP-B47 Subtend a BLSR from a Path Protection, page
NTP-B48 Subtend a BLSR from a BLSR, page
This procedure verifies that each ONS 15327 is ready for network
turn up before adding nodes to a network.
None
Chapter 3, "Turn Up Node"
Required
Onsite
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
Verify that the network does not have any unexplained alarms. If alarms are present, investigate and
resolve them before continuing. Refer to the Cisco ONS 15327 Troubleshooting Guide for
procedures.
Ensure that the alarm filter icon in the lower right corner is not indented. If so, click it once to turn
it off. When you are done checking for alarms, click the icon again to turn alarm filtering back on.
See the "DLP-B227 Disable Alarm Filtering" task on page 6-30
If the software is not the correct version, install the correct version from the ONS 15327 software
CD. Upgrade procedures are located on the CD. Follow the upgrade procedures appropriate to the
software currently installed on the node.
If the node defaults are not correct, complete the
procedure on page C-3.
9-2.
"NTP-B85 Change Node Timing" procedure on page
4-30—Complete as needed.
4-32—Complete as needed.
4-32—Complete as needed.
at any node on the network you will test. If
"NTP-B165 Import Network Element Defaults"
"NTP-B81 Change Node Management Information" procedure
"NTP-B201 Change CTC Network Access" procedure on page
Chapter 4 Turn Up Network
4-26—As needed, complete
4-29—As needed,
for instructions.
9-15.
March 2003
9-4.