Power Guidelines And Requirements; Network Cabling Specification - Cisco Catalyst 8300 Series Hardware Installation Manual

Power Guidelines and Requirements

• Mounted in a rack or cabinet (optional 4-point kit to use if rear support is required)
• Mounted on a wall
The positioning of your device and the arrangement of your equipment rack or wiring room are crucial factors
for optimal functionality. Placing equipment too closely, poor ventilation, and panels that are hard to reach
can lead to malfunctions, shutdowns, and pose challenges for maintenance. Ensure that both the front and
rear panels of the device are easily accessible during your planning process.
This information can help you plan the rack configuration for your equipment:
• Allow clearance around the rack for maintenance.
• Enclosed racks must have adequate ventilation. Ensure that the rack is not congested, because each device
• When mounting a chassis in an open rack, ensure that the rack frame does not block the intake or exhaust
Power Guidelines and Requirements
Check the power at your site to ensure that you are receiving "clean" power (free of spikes and noise). Install
a power conditioner if necessary.
Warning
Warning
Warning

Network Cabling Specification

• Ethernet cables for RJ45 ports.
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
12
generates heat. An enclosed rack should have louvered sides and a fan to provide cooling air. Heat
generated by equipment near the bottom of the rack can be drawn upward into the intake ports of the
equipment above it.
ports. If the chassis is installed on slides, check the position of the chassis when it is seated in the rack.
When installing the product, please use the provided or designated connection cables/power cables/AC
adaptors/batteries. Using any other cables/adaptors could cause a malfunction or a fire. Electrical Appliance
and Material Safety Law prohibits the use of UL-certified cables (that have the "UL" or "CSA" shown on the
cord), not regulated with the subject law by showing "PSE" on the cord, for any other electrical devices than
products designated by CISCO. Statement 371.
You are strongly advised to read the safety instruction before using the product.
https://www.cisco.com/web/JP/techdoc/pldoc/pldoc.html
When installing the product, please use the provided or designated connection cables/power cables/AC
adaptors. Statement 407.
This unit might have more than one power supply connection. To reduce risk of electric shock, all connections
must be removed to de-energize the unit. Statement 1028.
Prepare for Installation