(Optional) Change Management Network Settings At The Cli - Cisco Firepower 1010 Getting Started Manual

Firepower Threat Defense Deployment with CDO

(Optional) Change Management Network Settings at the CLI

If you cannot use the default management IP address, then you can connect to the console port and perform
initial setup at the CLI, including setting the Management IP address, gateway, and other basic networking
settings. You can only configure the Management interface settings; you cannot configure inside or outside
interfaces, which you can later configure in CDO or FDM.
Note You cannot repeat the CLI setup script unless you clear the configuration; for example, by reimaging. However,
all of these settings can be changed later at the CLI using configure network commands. See the
command
Procedure
Step 1
Connect to the FTD console port. See
Log in with the admin user and the default password, Admin123.
You connect to the FXOS CLI. The first time you log in, you are prompted to change the password. This
password is also used for the FTD login for SSH.
Note
Example:
firepower login: admin
Password: Admin123
Successful login attempts for user 'admin' : 1
[...]
Hello admin. You must change your password.
Enter new password: ********
Confirm new password: ********
Your password was updated successfully.
[...]
firepower#
Step 2 Connect to the FTD CLI.
connect ftd
Example:
firepower# connect ftd
>
reference.
If the password was already changed, and you do not know it, you must reimage the device to reset
the password to the default. See the
(Optional) Change Management Network Settings at the CLI
Access the FTD and FXOS CLI, on page 55
FXOS troubleshooting guide
Cisco Firepower 1010 Getting Started Guide
FTD
for more information.
for the reimage procedure.
33