Install Ons 15327 Cards; Table 1-3 Card Ports, Line Rates, And Connectors - Cisco ONS 15327 User Documentation

Chapter 1 Hardware Installation
The XTC slots host both XTC-14 and XTC-28-3 cards. XTC cards are required for system operation.
The MIC slots host MIC A and MIC B cards. The MIC slots are keyed to ensure that you install the MICs
in the correct slot. Install MIC A in the bottom MIC slot (Slot 8) and MIC B in the top MIC slot (Slot
7). MICs are also required for system operation. Make DS-1 and DS-3 connections using the connectors
on the MICs. Refer to
Table 1-3
optical and electrical cards.
Table 1-3
Interface
DS-1
DS-3
E10/100-4
OC-3 IR 1310
OC-12 IR 1310
OC-12 LR 1550
OC-48 IR 1310
OC-48 LR 1550
Procedure: Install ONS 15327 Cards
Open the card ejectors.
Step 1
Step 2 Slide the cards along the guide rails into the desired card slot.
Close the ejectors.
Step 3
Lock the cards into place by tightening the ejector locking screws.
Step 4
June 2002
Chapter 13, "Card Reference,"
lists the number of ports, line rates, connector options, and connector locations for ONS 15327
Card Ports, Line Rates, and Connectors
Ports
1–28
3
4
4
1
1
1
1
for more information about ONS 15327 cards.
Line Rate per Port Connector Types
1.544 Mbps CHAMP
Connector
44.736 Mbps BNC
10/100 Mbps RJ-45
155.52 Mbps LC
(STS-3)
622.08 Mbps SC
(STS-12)
622.08 Mbps SC
(STS-12)
2488.32 Mbps SC
(STS-48)
2488.32 Mbps SC
(STS-48)
Cisco ONS 15327 User Documentation, R3.3
Card Installation and Turn-Up
Connector
Location
MIC Faceplate
MIC Faceplate
E10/100-4
Card Faceplate
OC-3 IR 1310
Card Faceplate
OC-12 IR 1310
Card Faceplate
OC-12 LR 1550
Card Faceplate
OC-48 IR 1310
Card Faceplate
OC-48 LR 1550
Card Faceplate
1-17