Ntp-H156 Install The Filler Cards - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 1 Install the Cisco ONS 15310-MA SDH

NTP-H156 Install the Filler Cards

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
Caution Make sure you install the appropriate filler card for the slot where you are installing the card. Filler
card(s) for empty traffic card slots have the product ID 15310-EXP-FILLER, and filler cards for empty
15310E-CTX-K9 card slots have the product ID 15310-CTX-FILLER.
Step 1 Open the card ejector at the top of the card.
Step 2 Slide the card along the guide rails into the slot.
Step 3 Close the ejector by firmly pushing it downward.
Note
Step 4 When you log into CTC, verify that the card appears properly in CTC node view.
Continue with the
Step 5
procedure on page
Stop. You have completed this procedure.
78-19416-01
This procedure installs the filler cards (blank faceplates) in any unused
ONS 15310-MA SDH traffic or 15310E-CTX-K9 card slot. The filler cards
are detectable in CTC.
Filler card(s) for empty traffic card slots (15310-EXP-FILLER) and/or a
filler card for empty 15310E-CTX-K9 card slots (15310-CTX-FILLER)
DLP-H8 Turn On and Verify DC Office Power on the ONS 15310-MA
SDH, page 16-9
As needed
Onsite
Retrieve or higher
The filler cards are hot-pluggable, so they can be inserted or removed without turning off the
power to the ONS 15310-MA SDH.
"NTP-H157 Install Wires to Alarm, Timing, Craft, LAN, and UDC Pin Connections"
1-26.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Required Tools and Equipment
1-25