A/C Module Assembly - SSANGYONG Rexton Y200 Manual

7B-24 GENERAL HVAC SYSTEM
2. Remove the high/low pressure pipe lines.
3. Remove the high/low pressure pipe lines from the
evaporator.
YAD7B490
Installation Procedure
Notice: Discard the used O-ring and sealing washer.
1. Installation should follow the removal procedure
in the reverse order.
2. Tighten the flange nut securing the high pressure
line with the specified torque.
•
flange nut at compressor
•
flange nut at evaporator
3. Evacuate and recharge the A/C system.

A/C MODULE ASSEMBLY

Removal Procedure
1. Discharge the coolant from the system.
2. Discharge and recover the refrigerant from the
system.
3. Disconnect the inlet and outlet hose of the heater.
4. Disconnect the high/low pressure pipe from the
evaporator core.
5. Remove five bolts securing the A/C module.
•
two bolts at evaporator
•
two bolts at heater core
YAD7B500
•
a bolt at I/P
6. Remove the instrument panel.
7. Remove the fiber panel.
8. Remove the A/C module assembly.
Installation Procedure
1. Installation should follow the removal procedure
in the reverse order.
2. Tighten five bolts securing A/C module with the
specified torque.
3. Recharging the coolant.
4. Evacuate and recharge the A/C system.
SSANGYONG Y200