SSANGYONG Rexton Y200 Manual page 1512

SSANGYONG Y200
5. Remove wind shield glass
6. Using knife, remove sealant of wind shield glass
and frame.
Notice: In order to prevent damage of painting,
approximately 1mm of sealant should not be
removed from body.
YAD9C1P0
Installation
1. Clean up section to spread primer of wind shield
glass by washing.
1) Section of washing keep distance 15 mm from
the end of glass.
2) After using gauze 20 times, gauze is thrown
away.
3) Gauze is a solvent (isopropyl alcohol), gauze
keep wet completely.
4) Keep an eye on the washed section of glass
not to be touched by any thing polluted.
5) After washed glass, spread primer on the glass
YAD9C1Q0
section of wet state.
2. Install new wind shield moulding on wind shield
glass.
Notice: After spreading sealant on the glass,
glass should be installed within 5 minutes.
YAD9C1R0
3. Spread sealant on the wind shield.
Notice:
1) If shape of spreading is not uniform, thickness
of spreading is not uniform after installing
wind shield, leaking of water may occur.
2) As sealant is spreading, due to interfering of
nozzle, keep eye on for glass moulding, glass
dam not to drop.
YAD9C1S0
BODY EXTERIOR 9C-43