SSANGYONG Y200
COMPRESSOR
Disassembly and Assembly Procedure
1. Remove the compressor.
2. Remove the clutch driver.
•
Install the compressor holding fixture to the
compressor and hold the compressor holding
fixture using a bench vise.
•
Use the clutch hub holding tool to keep the
clutch drive plate and the hub assembly from
YAD7B510
turning to remove the shaft nut.
•
Remove the snap ring using the ring plier.
•
Remove the clutch drive using the special tool.
YAD7B520
•
Remove the clutch shaft key and spring.
YAD7B530
GENERAL HVAC SYSTEM 7B-25
UNIT REPAIR