Belt Pretensioner; Sensing And Diagnostic Module (Sdm) - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200

BELT PRETENSIONER

Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Remove the upper belt bolt and disconnect the
panel.
3. Disconnect the airbag wiring connector.
4. Remove the mounting bolt of the belt pretensioner
and remove the belt assembly.
YAD8B210
5. Tighten the pretensioner mounting bolt as the
specified torque.
Installation should follow the removal procedure
in the reverse order.
YAD8B220
SENSING AND DIAGNOSTIC
MODULE (SDM)
Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Remove the I/P center panel and the console
panel.
3. Remove the SDM connector.
YAD8B230
4. Remove the SDM mounting bolt and remove the
SDM assembly.
5. Installation should follow the removal procedure
in the reverse order.
YAD8B240
RESTRAINTS 8B-19