SSANGYONG Rexton Y200 Manual page 1435

Code Fault Contents
51h Passenger side airbag circuit,
short to ground
52h Communication malfunction of
the driver side airbag
53h Internal fault of the driver side
airbag sensor
54h Passenger side airbag sensor,
open/short to battery voltage
55h Passenger side airbag sensor,
short to ground
56h Communication malfunction of
the passenger side airbag
57h Internal fault of the passenger
side airbag sensor
17h Battery voltage too high
18h Battery voltage too low
1Eh SDM internal fault
(Initialization fault)
1Fh SDM internal fault
Caution:
•
Use only the scan tool to check the airbag
module and the sensing and diagnostic module
(SDM). Never measure the resistance of an airbag
module with an ohmmeter. An ohmmeter's
battery can deploy the airbag and cause injury.
•
Before testing, disconnect the negative battery
cable. Wait 1 minute for the SDM capacitor to
discharge. The capacitor supplies reserve power
to deploy the airbags, even if the battery is
SSANGYONG Y200
Check the connection of the driver side airbag sensor connector.
Check the wiring condition of the driver side airbag sensor.
Check the bending of the airbag terminal.
Check the connection of the driver side airbag sensor connector.
Check the wiring condition of the driver side airbag sensor.
Check the bending of the airbag terminal.
Check the connection of the driver side airbag sensor connector.
Check the wiring condition of the driver side airbag sensor.
Check the bending of the airbag terminal.
Check the connection of the passenger side airbag sensor
connector.
Check the wiring condition of the passenger side airbag sensor.
Check the bending of the airbag terminal.
Check the connection of the passenger side airbag sensor
connector.
Check the wiring condition of the passenger side airbag sensor.
Check the bending of the airbag terminal.
Check the connection of the passenger side airbag sensor
connector.
Check the wiring condition of the passenger side airbag sensor.
Check the bending of the airbag terminal.
Check the connection of the passenger side airbag sensor
connector.
Check the wiring condition of the passenger side airbag sensor.
Check the bending of the airbag terminal.
Check generator output voltage.
Check the battery voltage.
Check the bending of the airbag terminal.
Check generator output voltage.
Check the battery voltage.
Check the bending of the airbag terminal.
Replace the SDM.
Replace the SDM.
disconnected. Unintentional deployment of the
airbags can cause injury.
•
Do not attempt to repair the supplemental
inflatable restraints (SIR) wiring harness. An SIR
repair can create a high-resistance connection
which can keep the airbags from deploying when
needed, resulting in injury.
RESTRAINTS 8B-15
Check