Check And Adjust Tail Gate - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200

CHECK AND ADJUST TAIL GATE

Lock striker of back door consists of striker and tail
gate striker plate. Tail gate striker plate can be
adjusted easily by fixing bolt of striker, up and down,
forward and backwards. Lock of back door is linking
striker and then turn to position of closing.
Notice: As latch of tail gate and glass latch is installed,
bolt of ground should be used.
YAD9C0G0
Adjust Striker Forward and Backward, Left
and Right
Adjusting of striker of tail gate to forward and backward,
left and right is required in, case of damage of frame
due to collision, wind-noise, difficulty of opening and
closing. If striker is adjusted to forward and backward,
left and right, proceed to repair as following.
1. Tail gate keep on the one line.
2. Release fixing bolt of striker of tail gate.
3. Plate of plotting gauge moves little bit to end of
striker screw, tail gate striker plate is put to adjust
the position which is wanted.
YAD9C0H0
Notice: To protect section of screw from damage,
while tail gate striker plate is adjusted, flat rotary
pile is used for adjusting.
4. As adjusting is required beyond of limit of distance
movable, in order to make big hall, electrical hand
drill or flat rotary pile (3/8") is used.
5. According to direction adjusted, tighten fixing bolt
of striker.
6. Proceed to adjust up and down.
YAD9C0J0
BODY EXTERIOR 9C-35