Tail Gate Crank - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200
Adgusting Up and Down, Left and Right
Adjusting striker up and down, left and right is required
in following case, such as damage of vehicle collision,
installation of new weather strip , wind-noise, difficulty
of opening and closing door, in case adjusting up and
down, left and right, proceed to repair the following.
1. Door keep on the one line between door lock fork
and striker.
2. Release fixing bolt of door striker.
3. Plate of plotting gauge moves little bit to end of
striker screw, plate of plotting gauge is put to
adjust the position which is wanted.
YAD9C910
Notice: To protect section of screw from damage,
while plate of plotting gauge is adjusted, flat rotary
pile is used for adjusting.
4. As adjusting is required beyond of limit of distance
movable, in order to make big hall , electrical hand
drill or flat rotary pile (3/8¢) is used.
5. According to direction adjusted, tighten fixing bolt
of striker.

TAIL GATE CRANK

Removal and Installation
1. Separate the negative (-) terminal of battery.
2. Remove inner panel trim cover of tail gate.
YAD9C920
3. Remove inner panel trim vinyl seal of tail gate.
4. Separate wiring connector of actuator.
5. Separate outside handle, glass handle.
6. Separate safety rod.
7. Remove tail gate, glass latch rod.
YAD9C930
BODY EXTERIOR 9C-31