Too Much Heat - SSANGYONG Rexton Y200 Manual

Check
Mode Is there too much heat
switch to when the mode switch is
the floor in the floor position?
position
Is the airflow proper?
Is the heavy airflow?
Does the airflow change?
Is the airflow proper?
Can you hear the sound
of the temperature door
slam?
SSANGYONG Y200
HEATING AND VENTILATION SYSTEM 7A-11

TOO MUCH HEAT

Yes Set the temperature control switch to defrost position.
No Set the mode switch to the vent position.
Yes Set the blower speed to 4th.
Set the temperature control switch to full hot.
Turn the ignition "ON".
Check the airflow and attachment at the foolr outlet.
No Check the door travel, the cables, the controls and the
linkage for the defrost position and then repair or replace as
needed.
Yes Check the door travel, the cables, the controls and the
linkage for the full hot, full cold position and then adjust as
needed.
No Check for a change in the airflow at different blower speed.
Check the change.
Yes System OK
No Go to "Blower Electrical"
Yes Turn the ignition "OFF".
Turn the temperature control knob to full hot, then rapidly to
full cold.
No Check the system case for leaks and check the floor outlet
attachment.
Yes Adjust the vent door to vent mode.
No Check the door travel, the cables, the controls and the
linkage for the full hot, full cold position and then adjust as
needed.
Action