Front Door Glass Run And Regulator - SSANGYONG Rexton Y200 Manual

9C-38 BODY EXTERIOR
2. Remove glass of front door.
1) Release fixing screw (2 ea) of glass, at this
time, position of plate of regulator carrier should
be position of installation.
2) Remove glass.
Notice: If glass interfere to the body, damage of
section of body painting may happen, so glass
should not interfere body.
YAD9C0T0
3. Install reverse order of removal.
Fixing Bolt of Glass
Notice: If water of soap spread on contacting
section between glass run and glass, so that, can
be installed easily.
YAD9C0U0
FRONT DOOR GLASS RUN AND
REGULATOR
Removal and Installation
1. Remove door trim, seal, and window glass.
2. Remove door glass run from door .
YAD9C0V0
3. After releasing fixing nut of door regulator, and
then remove motor connector of power window.
YAD9C0W0
3 N•m (26 lb-ft)
SSANGYONG Y200