Heater Suction And Discharge Hose - SSANGYONG Rexton Y200 Manual

7A-18 HEATING AND VENTILATION SYSTEM
•
Tighten the blower module assembly with
retaining nuts.
Retaining Bolt
YAD7A170
•
Connect the blower motor connector and install
the heater hose and A/C pipe.
YAD7A180
HEATER SUCTION AND
DISCHARGE HOSE
Removal & Installation Procedure
1. Drain the coolant.
2. Remove the clips and push back the suction
heater hose clamp near the fire wall.
3. Twist the hose slowly from the left side to the right
side to loosen the connection between the hose
and the tube.
4. Remove the hose end from the tube.
YAD7A190
5. Remove the clip and push back the heater suction
hose at engine block side.
6. Remove the heater suction hose and discharge
hose on the vehicle.
7. Installation should follow the removal procedure
in the reverse order.
YAD7A200
5 N•m (44 lb-in)
SSANGYONG Y200