Rear Glass Run/ Regulator/ Channel - SSANGYONG Rexton Y200 Manual

9C-40 BODY EXTERIOR
3. Remove seal and door trim.
YAD9C1B0
4. Remove rear door glass.
1) Release screw (move up carrier plate of
regulator).
2) Extract glass upwards.
Notice: If glass interfere to the body, damage of
section of body painting may happen, so glass
should not interfere body.
YAD9C1C0
5. Install reverse order of removal.
Fixing Nut of Glass
Notice: As door glass run is installed, water of
soap spead on section of glass run so door glass
run can be installed easily.
YAD9C1D0
REAR GLASS RUN/ REGULATOR/
CHANNEL
1. Remove door trim, seal, and glass
2. Remove glass run.
•
Pull door glass run internally, and then extract
glass run.
Notice: As door glass run is installed, water of
soap spead on section of glass run so door glass
run can be installed easily.
YAD9C1E0
3 N•m (26 lb-ft)
SSANGYONG Y200