Ip Igmp Ssm-Map; Ip Igmp Static-Group - Dell Force10 Z9000 Reference Manual

ip igmp ssm-map

Use a statically configured list to translate (*,G) memberships to (S,G) memberships.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip igmp ssm-map std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them with (*,G)
state, use the ip igmp ssm-map std-access-list source-address command.
Parameters
std-access-list
source-address
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in the
Information IGMP groups. You may not use extended access lists with this command. When you configure
a static SSM map and the router cannot find any matching access lists, the router continues to
accept (*,G) groups.
Related ip access-list standard
Commands

ip igmp static-group

Configure an IGMP static group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip igmp static-group {group address [exclude [source address]]
| [include {source address}]}
To delete a static address, use the no ip igmp static-group {group address
[exclude [source address]] | [include {source address}]} command.
Parameters
group address
674
Specify the standard IP access list that contains the mapping rules
for multicast groups.
Specify the multicast source address to which the groups are
mapped.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
– creates a standard access list to filter based on IP address.
Enter the group address in dotted decimal format (A.B.C.D).