Ip Igmp Ssm-Map - Dell S4810 Reference Manual

ip igmp ssm-map

To translate (*,G) memberships to (S,G) memberships, use a statically configured list.
S4810
Syntax
ip igmp ssm-map std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them
with (*,G) state, use the ip igmp ssm-map std-access-list source-
address command.
Parameters
std-access-list
source-address
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected
Information in the IGMP groups. You may not use extended access lists with this command.
When you configure a static SSM map and the router cannot find any matching
access lists, the router continues to accept (*,G) groups.
Related ip access-list standard
Commands
724
Specify the standard IP access list that contains the mapping
rules for multicast groups.
Specify the multicast source address to which the groups are
mapped.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
— creates a standard access list to filter based on IP address.
Internet Group Management Protocol (IGMP)