Bgp Client-To-Client Reflection; Bgp Cluster-Id - Dell C9000 Series Reference Manual

bgp client-to-client reflection

Allows you to enable route reflection between clients in a cluster.
C9000 Series
Syntax
bgp client-to-client reflection
To disable client-to-client reflection, use the no bgp client-to-client
reflection command.
Defaults Enabled when a route reflector is configured.
Command Modes ROUTER BGP
Command History
Version
9.9(0.0)
9.2(1.0)
8.2.1.0
7.4.1.0
Usage Information Route reflection to clients is not necessary if all client routers are fully meshed.
Related
Commands

bgp cluster-id

Assign a cluster ID to a BGP cluster with more than one route reflector.
C9000 Series
Syntax
bgp cluster-id {ip-address | number}
To delete a cluster ID, use the no bgp cluster-id {ip-address | number}
command.
Parameters
ip-address
number
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
• bgp cluster-id – assigns an ID to a BGP cluster with two or more route reflectors.
• neighbor route-reflector-client
Enter an IP address as the route reflector cluster ID.
Enter a route reflector cluster ID as a number from 1 to
4294967295.
– configures a route reflector and clients.
Border Gateway Protocol 567