Show Ip Bgp Dampened-Paths - Dell C9000 Series Reference Manual

Version
7.8.1.0
7.7.1.0
Usage Information
The higher the administrative distance assigned to a route means that your confidence
in that route is low. Routes assigned an administrative distance of 255 are not installed
in the routing table. Routes from confederations are treated as internal BGP routes.
Related
router bgp
Commands

show ip bgp dampened-paths

View BGP routes that are dampened (non-active).
C9000 Series
Syntax
show ip bgp [vrf vrf-name] [ipv4 {multicast | unicast} | ipv6
unicast] dampened-paths
Parameters
vrf vrf-name
ipv4 multicast
ipv4 unicast
ipv6 unicast
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Description
Introduced on the S-Series.
Introduced on the C-Series.
CAUTION: Dell Networking recommends not changing the administrative
distance of internal routes. Changing the administrative distances may cause
routing table inconsistencies.
— enters ROUTER mode on the switch.
(OPTIONAL) Enter the keywords vrf and then the name of the
VRF to view routes that are affected by a specific community list
corresponding to that VRF.
(OPTIONAL) Enter the keyword ipv4 followed by the keyword
multicast to view information related only to ipv4 multicast
routes.
(OPTIONAL) Enter the keywords ipv4 followed by the keyword
unicast to view information related only to ipv4 unicast routes.
(OPTIONAL) Enter the keyword ipv6 followed by the keyword
unicast to view information related only to ipv6 unicast routes.
• EXEC
• EXEC Privilege
Border Gateway Protocol 546