Dell C9000 Series Reference Manual page 623

To stop redistribution of OSPF routes, use the no redistribute ospf process-id
command.
Parameters
process-id
match external {1 |
2}
match internal
route-map map-
name
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version
9.9(0.0)
9.2(1.0)
8.2.1.0
7.4.1.0
Usage Information When you enter the redistribute ospf process-id command without any other
parameters, the software redistributes all OSPF internal routes, external type 1 routes,
and external type 2 routes.
Enter the number of the OSPFv3 process. The range is 1 to
65535.
(OPTIONAL) Enter the keywords match external to
redistribute OSPF external routes. You can specify 1 or 2 to
redistribute those routes only.
(OPTIONAL) Enter the keywords match internal to
redistribute OSPFv3 internal routes only.
(OPTIONAL) Enter the keywords route-map followed by the
name of an established route map. Only the following ROUTE-
MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If you do not configure the route map, the default is deny (to
drop all routes).
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
Border Gateway Protocol 623