Neighbor Next-Hop-Self - Dell C9000 Series Reference Manual

warning-only
Defaults threshold = 75
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version
9.9(0.0)
9.2(1.0)
8.2.1.0
7.4.1.0
Usage Information If you configure the neighbor maximum-prefix command and the neighbor
receives more prefixes than allowed by the neighbor maximum-prefix command
configuration, the neighbor goes down and the show ip bgp summary command
displays (prfxd) in the State/PfxRcd column for that neighbor. The neighbor remains
down until you enter the clear ip bgp command for the neighbor or the peer group
to which the neighbor belongs or you enter the neighbor shutdown and neighbor
no shutdown commands.
Related show ip bgp summary
Commands

neighbor next-hop-self

Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for IBGP).
C9000 Series
Syntax
neighbor {ipv6-address | peer-group-name} next-hop-self
To return to the default setting, use the no neighbor {ipv6-address | peer-
group-name} next-hop-self command.
Parameters
ipv6-address
peer-group-name
percentage of the maximum value, the software sends a
message. The range is 1 to 100 percent. The default is 75.
(OPTIONAL) Enter the keywords warning-only to set the
router to send a log message when the maximum value is
reached. If you do not set this parameter, the router stops
peering when the maximum number of prefixes is reached.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
– displays the current BGP configuration.
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
(OPTIONAL) Enter the name of the peer group.
Border Gateway Protocol 605